請輸入產品關鍵字:
郵編:215128
聯系人:徐雯
電話:0512-65656707
傳真:0512-65648473
手機:13806133779
留言:發送留言
個性化:www.szhxinda.cn
網址:www.szhxinda.com
商鋪:http://true-witness.com/st1679/
高低溫試驗箱箱內空氣循環設計要求
點擊次數:1750 發布時間:2014-9-9
高低溫試驗箱箱內空氣循環設計要求
1.高低溫試驗箱對由于尺寸大或者高散熱而不能使用自由空氣條件試驗箱試驗的試驗樣品,應使用帶空氣流動(有強迫空氣循環)的試驗箱,除有關試驗箱尺寸以外,對自由空氣試驗箱的其他所有要求,有強迫空氣循環試驗箱的設備均適用。
1 high low temperature test box due to the large size and high heat dissipation and free air condition test chamber test cannot use a test sample, should be used with air flow (forced air circulation) test box, except relevant test box size, the free air chamber of the other requirements, forced air circulation chamber the equipment is applicable.
2.速度應符合這樣的要求:不應太小,以保證高低溫試驗箱試驗樣品在試驗時不致過熱,有不應太大,以致試驗樣品在試驗時出現過冷,但是,盡管順暢地變得氣流的速度是有利的,然而在實踐中業已發現,采用0.5m/s的風速是一種較好的折衷方案。
2 speed shall comply with such requirements: should not be too small, so as to ensure the high low temperature test box test sample is not overheating in the test, there should not be too large, so that the test sample in the trial when cold, but, although smoothly become airflow velocity is favorable, however it has been found that in practice, the wind speed by 0.5m/s is a good compromise.
3.宜盡可能均勻一致,氣流方向宜垂直向上,以將由上面對流所引起的氣流變化縮減到zui低限度,如果風扇在前箱產生正壓,然后使空氣從前箱經過過濾器(如玻璃纖維欄網)逸出,則可得到均勻的氣流,在前箱還可裝設幾個控制該高低溫試驗箱溫度的加熱器,或者,利用把加熱器和過濾器的作用結合在一起的網狀加熱器。
3 should be as uniform as possible, the airflow direction is vertical, to cut the air caused by the convection of the above to a minimum, if the fan to generate positive pressure in the first box, and then make the air once box through the filter (such as glass fiber nets) to escape, then can get the flow evenly, heater, in the front box installed several control the high low temperature test box temperature can be or, to use the heater and a filter role together with mesh heater.