人幽門螺旋桿菌（HP）酶聯免疫分析試劑盒使用說明書

人幽門螺旋桿菌（HP）酶聯免疫分析試劑盒使用說明書
本試劑盒僅供研究使用。
96T
使用目的：
本試劑盒用于測定人血清、血漿及相關液體樣本中幽門螺旋桿菌（HP）表達。
實驗原理
本試劑盒應用雙抗體夾心法測定標本中人幽門螺旋桿菌（HP）表達。用純化的人幽門螺旋
桿菌（HP）抗體包被微孔板，制成固相抗體，可與樣品中幽門螺旋桿菌（HP）相結合，經
洗滌除去未結合的抗原和其他成分后再與HRP 標記的幽門螺旋桿菌（HP）抗體結合，形成
抗體-抗原-酶標抗體復合物，經過*洗滌后加底物TMB 顯色。TMB 在HRP 酶的催化下
轉化成藍色，并在酸的作用下轉化成zui終的黃色。用酶標儀在450nm 波長下測定吸光度（OD
值），與CUTOFF 值相比較，從而判定標本中幽門螺旋桿菌（HP）的存在與否。
試劑盒組成
1 30 倍濃縮洗滌液20ml×1 瓶7 終止液6ml×1 瓶
2 酶標試劑6ml×1 瓶8 陽性對照0.5ml×1 瓶
3 酶標包被板12 孔×8 條9 陰性對照0.5ml×1 瓶
4 樣品稀釋液6ml×1 瓶10 說明書1 份
5 顯色劑A 液6ml×1 瓶11 封板膜2 張
6 顯色劑B 液6ml×1/瓶12 密封袋1 個
標本要求
1．標本采集后盡早進行提取，提取按相關文獻進行，提取后應盡快進行實驗。若不能
馬上進行試驗，可將標本放于-20℃保存，但應避免反復凍融
2．不能檢測含NaN3 的樣品，因NaN3 抑制辣根過氧化物酶的（HRP）活性。
操作步驟
1. 編號：將樣品對應微孔按序編號，每板應設陰性對照2 孔、陽性對照2 孔、空白對照1
孔（空白對照孔不加樣品及酶標試劑，其余各步操作相同）
2. 加樣：分別在陰、陽性對照孔中加入陰性對照、陽性對照50μl。然后在待測樣品孔先
加樣品稀釋液40μl，然后再加待測樣品10μl。加樣將樣品加于酶標板孔底部，盡量不
觸及孔壁，輕輕晃動混勻，
3. 溫育：用封板膜封板后置37℃溫育30 分鐘。
4. 配液：將30 倍濃縮洗滌液用蒸餾水30 倍稀釋后備用
5. 洗滌：小心揭掉封板膜，棄去液體，甩干，每孔加滿洗滌液，靜置30 秒后棄去，如此
重復5 次，拍干。
6. 加酶：每孔加入酶標試劑50μl，空白孔除外。
7. 溫育：操作同3。
8. 洗滌：操作同5。
9. 顯色：每孔先加入顯色劑A50μl，再加入顯色劑B50μl，輕輕震蕩混勻，37℃避光顯色
15 分鐘.
10. 終止：每孔加終止液50μl，終止反應（此時藍色立轉黃色）。
11. 測定：以空白空調零，450nm 波長依序測量各孔的吸光度（OD 值）。測定應在加終止
液后15 分鐘以內進行。
計算和結果判定：
試驗有效性：陽性對照孔平均值≥1.00; 陰性對照平均值≤0.10
臨界值（CUT OFF）計算：臨界值=陰性對照孔平均值+0.15
陰性判定：樣品OD 值< 臨界值（CUT OFF）者為幽門螺旋桿菌（HP）陰性
陽性判定：樣品OD 值≥ 臨界值（CUT OFF）者為幽門螺旋桿菌（HP）陽性
。
注意事項
1．操作嚴格按照說明書進行，本試劑不同批號組分不得混用。
2．試劑盒從冷藏環境中取出應在室溫平衡15-30 分鐘后方可使用，酶標包被板開封后如未
用完，板條應裝入密封袋中保存。
3．濃洗滌液可能會有結晶析出，稀釋時可在水浴中加溫助溶，洗滌時不影響結果。
4． 封板膜只限一次性使用，以避免交叉污染。
5．底物請避光保存。
6．試驗結果判定必須以酶標儀讀數為準，使用雙波長檢測時，參考波長為630nm
7．所有樣品，洗滌液和各種廢棄物都應按傳染物處理。終止液為2M 的硫酸，使用時必須
注意安全。
保存條件及有效期
1．試劑盒保存：；2-8℃。
2．有效期：6 個月
Human HP
FOR RESEARCH USE ONLY
96 determinations
Purpose
This kit allows for the determination of HP concentrations in Human serum, and other
biological fluids.
Principle of the assay
The kit assay HP level in the sample，use Purified HP antibody to coat microtiter plate
wells, make solid-phase antibody, then add HP to wells, Combined With HP, after washing and
removing non-combinative antibody and other components ,then Combined HP antibody
which with HRP labeled become antibody – antigen - enzyme- antibody complex, after washing
Compley, Add TMB substrate solution,, TMB substrate becomes blue color At HRP
enzyme-catalyzed, reaction is terminated by the addition of a sulphuric acid solution and the
color change is measured spectrophotometrically at a wavelength of 450 nm. Compared with
the CUTOFF value, according to this to judge HP exist in the sample or not.
Materials provided with the kit
1 wash solution 20ml× 1bottle 7 Stopp Solution 6ml× 1 bottle
2 HRP-Conjugate reagent 6ml× 1 bottle 8 Positive control 0.5ml× 1 bottle
3 Microelisa stripplate 12well× 8strips 9 Negative control 0.5ml× 1bottle
4 Sample diluent 6ml× 1 bottle 10 Instruction 1
5 Chromogen Solution A 6ml× 1 bottle 11
Closure plate
membrane
2
6 Chromogen Solution B 6ml× 1 bottle 12 Sealed bags 1
Specimen requirements
RD
1. extract as soon as possible after Specimen collection,and according to the relevant
literature, and should be experiment as soon as possible after the extraction. If it can’t,
specimen can be kept in -20 ℃ to preserve, Avoid repeated freeze-thaw cycles.
2. Can’t detect the sample which contain NaN3, because NaN3 inhibits HRP active.
Assay procedure
1.Number: to sample correspond microtitration well and Number Sequence, each plate should
be set feminine comparison 2 wells, masculine comparison 2 wells, blank comparison 1
well(don’t add sample and HRP-Conjugate reagent to blank comparison well, other each step
the operation are same).
2.add sample：separay add Positive control and Negative control 50μl to the Positive and
Negative well . add Sample dilution 40μl to testing sample well, then add testing sample 10μl.
add sample to the bottom of ELISA plates coated well , don’t touch the well wall as far as
possible, and Gently mix.
3.Incubate: After closing plate with Closure plate membrane ,incubate for 30 min at 37℃.
4.Configurate liquid: 30-fold (or 20-fold)wash solution diluted 30-fold (or 20-fold) with distilled
water until 600ml,and reserve.
5.washing：Uncover Closure plate membrane, discard Liquid, dry by swing, add washing buffer
to every well, still for 30s then drain, repeat 5 times, dry by pat.
6.add enzyme：Add HRP-Conjugate reagent 50μlto each well, except the blank well.
7.incubate：Operation with 3.
8.washing：Operation with 5.
9.color：Add Chromogen Solution A 50ul and Chromogen Solution B to each well, evade the
light preservation for 15 min at 37℃
10.Stop the reaction：Add Stop Solution50μl to each well, Stop the reaction(the blue color
change to yellow color).
11. assay：take blank well as zero , Read absorbance at 450nm after Adding Stop Solution and
within 15min.
Determine the result
Test validity: the average of Positive control well≥1.00; the average of Negative control well
≤0.10.
Calculate Critical(CUT OFF) : Critical= the average of Negative control well + 0.15.
Negative control: sample OD< Calculate Critical(CUT OFF) is HP Negative control.
Positive control: ample OD≥ Calculate Critical(CUT OFF) is HP Positive control.
Important notes
1.Please according to use instruction strictly, Do not mix reagents with those from other lots.
2.The kit takes out from the refrigeration environment should be balanced 15-30 minutes in
the room temperature then use, ELISA plates coated if has not use up after opened, the
plate should be stored in Sealed bag.
3.washing buffer will Crystallization separation, it can be heated the water helps dissolve
when dilute . Washing does not affect the result.
4.Closure plate membrane only limits the disposable use, in order to avoid the overlapping
pollution
5.The substrate please evade the light preservation.
6.The test result determination must take the microtiter plate reader as a standard, when use
dual-wavelength to assay, Reference wavelength is 630nm.
7.All samples, washing buffer and each kind of reject should according to infective material
process. Stopp Solution is 2M sulphuric acid. You must pay attention to safe when use .
Storage and validity
1．Storage： 2-8℃.
2．validity： six months.